Defend for safety, for efficient production, crucial issue is safeguarded with respect to the daily safety that is equipment with maintain; Accomplished, can prolong the service life of the machine not only, still can maintain from beginning to end and improve the treatment quality of the product, what realize stability finally is cost-effective.
The following all, please you are cogent and serious accomplish:
1, good ground connection
Body of bed of laser power source, machine tool must have good ground connection to protect, ground wire application is less than the special ground wire of 4Ω . Necessity depends on: (1) can make sure laser power source works normally, (2) can lengthen laser to run service life, (3) can prevent outside interference to cause a machine tool to beat, (4) prevent high-pressured discharge to cause circuit to injure accidentally. Good ground connection, be sure to be sure to!
2, cooling water wants expedite
No matter be to use tap water or circular water pump, must maintain current free to connect. Cooling water is the caloric that takes away laser to provide generation, water Wen Yue is tall, smooth output power is lower (with Wen Weijia of 15-20 ℃ water) ; The meeting when cutting off the water supply brings about blast tubal end because of heat is being accumulated inside laser antrum to crack, damage even laser power source. Inspect cooling water at any time so expedite it is very necessary. Have when conduit fold forcedly (dead turn) or fall off, when down to water pump is out of order, must seasonable rehabilitate, lest power drops,cause equipment breakdown even.
3, cleanness maintains, good platoon wind, wipe at any time
The clean conserve of the machine tool, it is the requirement that the machine tool works normally. The joint of just think person is not agile, how to still act? Same argument, machine tool slideway is component of tall accurate core, after every job is finished must wipe up, keep bright and clean and lubricant; Each bearing also wants fixed oiling, such ability make drive agile, treatment is accurate, prolong the service life of the machine tool.
4, environmental temperature and humidity
Environmental temperature should be in 5-35 ℃ limits. Of special attention is: If be in under freezing point in the environment,use, must accomplish: (1) prevent water of the loop inside laser canal to freeze, stop machine hind to must put water light thoroughly; (2) when switching on the mobile phone, laser electric current must warm-up ability of 5 minutes of above works, in day of overcast and rainy and damp environment, laser power source more need warm-up time some longer, maximum pressure just can be increased after the platoon is wet really, in case high-pressured circuit puncture.
Previous12 Next